Secure by default: Resetting with reset type 2

• Disconnect the power to the controller.
• Press and hold down the reset button with a non-conductive, pointed object.
• Hold down the reset button and switch the supply voltage of the controller on.
• Press and hold the reset button until the STAT LED lights up green. The process takes approx. 40 seconds.
  While the reset button is pressed, the LEDs behave as follows:
  • The CSEC LED starts to light up blue.
  • The STAT LED starts to flash yellow.
  • The STAT LED starts to light up green.
• Release the reset button as soon as the STAT LED lights up green.
  ↪ All LEDs go out.
  Shortly thereafter, the STAT LED starts to flash red/yellow.
  ↪ The controller is reset with reset type 2 and the recovery system is started.
• Connect the controller to your PC using a suitable Ethernet cable.
• Open your web browser.
• Open the recovery system via the URL http://192.168.1.10.
  If the recovery system does not open:
  Check whether the URL you entered in the web browser actually starts with “http://”.
  The recovery system cannot be opened via an HTTPS connection.
  Please note:
  • As long as the recovery system is active, the LNK and ACT LEDs on the Ethernet interface are switched off (even when the Ethernet connection is active).
  • As long as the recovery system is active, the reset button has no function.

You can perform the following actions in the recovery system: 

• Install new firmware
• Restart the controller with the existing firmware